LaCie 12big Rack Fibre 8 Bedienungsanleitung PDF herunterladen (Seite 9)

LaCie 12big Rack Fibre 8 System Overview

User Manual page 9

1.3. Enclosure Chassis

The 12big Rack Fibre 8 storage system design concept is based on

an SBB-compliant enclosure subsystem together with a set of plug-in

modules.

The 12big Rack Fibre 8 RAID enclosure as supplied consists of:

✦ Chassis and midplane with integral front ﬂange mounted op-

erator panel (1.3.3. Operator’s Panel).

✦ 12 front loading drive carrier slots that support either SAS or

SATA disk drives. SATA drives require an Active/Active MUX

transition card to be installed (1.4.5. Drive Carrier Module).

IMPORTANT INFO: Dummy Carriers modules must be installed

in all unused drive slots to maintain airﬂow, please refer to 1.4.5.4.

Dummy Carrier Modules.

✦ Two plug-in Power Cooling Modules (PCMs): 100-240V AC,

580W (1.4.1. Power Cooling Module).

✦ Two plug-in RAID Controller Modules each with Embedded

StorView Storage Management software (2.4.2. Drive Carrier

Module).

IMPORTANT INFO: If only one RAID Controller module is in-

stalled, then a Blank I/O module must be installed in the unused

bay. The primary RAID Controller should be installed in Bay #0

(upper most bay) and the secondary RAID Controller in Bay #1 (the

lower most bay), see Fig. 02.

✦ The chassis will consume 4 EIA units of rack space in a stan-

dard 19 inch rack cabinet. The rail mounting system is in-

cluded with the enclosure.

The 12big Rack Fibre Expansion enclosure as supplied consists of:

✦ Chassis and midplane with integral front ﬂange mounted op-

erator panel (1.3.3. Operator’s Panel).

✦ 12 front loading drive carrier slots that support either SAS or

SATA disk drives. SATA drives require an Active/Active MUX

transition card to be installed (1.4.5. Drive Carrier Module).

IMPORTANT INFO: Dummy Carriers modules must be installed

in all unused drive slots to maintain airﬂow, please refer to 1.4.5.4.

Dummy Carrier Modules.

✦ Two plug-in Power Cooling Modules (PCM): 100-240V AC,

580W (1.4.1. Power Cooling Module).

✦ Two plug-in Disk I/O Modules (2.4.2. Drive Carrier Module).

IMPORTANT INFO: If only one Disk I/O Module is installed, then

a Blank I/O module must be installed in the unused bay. The pri-

mary Disk I/O Module should be installed in Bay #0 (upper most

bay) and the secondary Disk I/O Module in Bay #1 (the lowest most

bay), see Fig. 03.

✦ The chassis will consume 4 EIA units of rack space in a stan-

dard 19 inch rack cabinet. The rail mounting system is in-

cluded with the enclosure.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 86 87

Kommentare zu diesen Handbüchern

Keine Kommentare

LaCie 12big Rack Fibre 8 Bedienungsanleitung Seite 9

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Festplatten-Arrays LaCie 12big Rack Fibre 8