LaCie 12big Rack Fibre 8 Bedienungsanleitung PDF herunterladen (Seite 18)

LaCie 12big Rack Fibre 8 System Overview

User Manual page 18

1.4.2.3. StoreView Management Software

The StorView Storage Management software is embedded on the

RAID Controller module and is a full-featured graphical HTML-

based software suite designed to conﬁgure, manage and monitor

the 12big Rack Fibre 8 and 12big Rack Fibre Expansion storage

solutions. The module is supplied conﬁgured with a base IP address

to allow the user to connect and access the controller’s embedded

StorView software. Please refer to 3.4. Starting StorView for further

information and the StorView Storage Management Software RAID

Module User Guide.

1.4.3. Disk I/O Module

The 12big Rack Fibre Expansion enclosure houses one or two Disk

I/O Modules. They provide drive expansion for the RAID enclosure.

When expanding the storage system, you may add up to seven Ex-

pansion enclosures. This will give you a total of eight enclosures

including the RAID enclosure for a maximum of 96 SAS or SATA

disk drives.

IMPORTANT INFO: Do not mix Disk I/O Modules and RAID

Controllers in the same enclosure.

Processors on the Disk I/O Modules provide enclosure management

and an interface to the devices on the backplane, Power Cooling

Modules and OPS panel, which monitors the internal functions. In

a dual module conﬁguration, these processors operate in a master-

slave conﬁguration to allow for path failover in the event of a single

module failure.

If only one Disk I/O Module is installed, a Blank I/O module must

be installed in the unused I/O Bay #1 (lower). The single Disk I/O

Module is installed in the I/O Bay #0 (upper).

Each Disk I/O Module has three SAS connectors and each connec-

tor has four adjacent LEDs. The LEDs indicate status or I/O activity

on that speciﬁc lane of the SAS port. The module also has a Fault

and ID LEDs. Refer to Table 04

for details on these LEDs.

In a multiple enclosure conﬁguration, the “OUT” port on the RAID

Controller or Disk I/O Module connects to the “IN” port on the

Disk I/O Module in the next Expansion enclosure (12big Rack Fibre

Expansion). Please refer to section 2.6. Cabling Multiple Enclosures

for more information on cabling Expansion enclosures.

continued on the next page>>

Fig. 12 - Disk I/O Module

Fig. 13 - Disk I/O Module Front Panel

TECHNICAL NOTE: The white diamond icon with arrow pointing

away from the connector indicates a SAS OUT port, and a white

circle icon with an arrow pointing towards the connector indicates a

SAS host IN port.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 86 87

Kommentare zu diesen Handbüchern

Keine Kommentare

LaCie 12big Rack Fibre 8 Bedienungsanleitung Seite 18

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Festplatten-Arrays LaCie 12big Rack Fibre 8